Menu Operations
30
5.5 Parental Lock
You can set a password for anyone who
wishes to operate the “Installation” menu.
You can also set the password to lock
channels. Below you find how to set and
change the password.
1. On “Parental Lock” press [OK] to open
a dialogue box and input the
password. After you entered the
correct password, you will see a
screen like beside:
2. Menu Lock: If Menu Lock is set to “Yes” then you need to enter the
password every time you want to open the menu. If set to “No” then you
can open the menu without entering the password first.
3. Channel Lock: If set to “Yes” then you need to enter the password before
you can see those channels which have been marked as locked channels
in the Channel menu. If set to “No” then even those channels can be
selected without entering the password first.
4. New Password: Here you can change the existing password. You should
do this after you set up the receiver the first time and every time when you
think that your password is known by unauthorized persons. To change the
password enter the new password in the “New Password” item and repeat
the same one in the “Confirm Password” item. If the passwords are not
identically then you will see a warning message. If you entered the same
new password in both fields then you will see the message “Saving Data,
Please Wait…”. From now on you need to use the new password to open
locked menus or locked channels.
NOTE: The default password is 0000
5. Press [MENU] to leave the “Parental Lock” menu.
5.6 LNB Power
Here you can set the power output to the LNB. If your receiver is connected to
the LNB directly then you need to set the LNB power to “On”. If your receiver is
connected to a multi switch(SMATV signal distribution system) then it may be
that you don’t need to provide the power to the LNB. But since this is depending
on the kind of installed distribution system we recommend you to contact your
installer or to refer to the user manual of this system to get the correct
information.
You also just can change this setting and check if you still can receive the
channels. If the LNB power is off and you still can see all channels then we
recommend this setting in order to save energy.