Basic Operations
6
2. Basic Operations
2.1 Switch on STB
Switch the [Device’s Main Power] switch on.
you will set Language, First Audio, Second Audio, LNB Power, Antenna Setup
and Multi Search.
? Frequently Asked Question
Q: The power of my STB is on and it is running in TV mode but the TV
screen shows nothing:
A: Make sure the TV set has been set to the correct video input(not the
TV channels). For example, if you have connected the unit to the
video1 input of the TV set then you need to select the corresponding
input of the TV. Mostly it is done with the AV button of the TVs remote
control unit.
Q: My STB is running in TV mode but the TV screen shows nothing
except one ball and “No Signal”.
A: That means the channel you selected has no signal. This can be
caused by several reasons:
1. The channel you selected is not from the satellite to which your dish is
pointing. Select another channel.
2. The signal of current TV channel is too weak. You can try to change to
other channels with a stronger signal. If the problems still exist, please
consult your local dealer or installer for technical service.
3. You selected the wrong LNB type in the installation menu or your DiSEqC
switch configuration is not correct.
2.2 Standby Mode:
1. Press [Power] button to switch from TV/radio mode to standby mode
2. In standby mode press [Power] button again to switch back to TV/radio
mode. The last active channel will be showed.
3. To switch off the STB complete press the main power button.
2.3 Channel +/-
In TV/radio mode press [Channel Up/Channel Down] to change channel.
2.4 Volume +/-
In TV/radio mode, press [Volume Up/Volume Down] to adjust volume.