Menu Operations
♦Press [Volume Up/Down / Channel Up/Down] to position the round mark.
♦Press [OK] to set your stone.
♦Press [MENU] to quit the game and return to the game menu.
6.4Factory Default
When you press [OK] on the “Factory
Default” item:
1.A dialogue box will occur where you need to enter the password.
2.After you input the correct password a warning message will be displayed like the one beside.
3.If you select “Yes” then all changes you made will be reset to default values. Make sure you really want to do this!
4.Press [MENU] in both steps will close the window without resetting the receiver.
6.5 Software Upgrade
1.This function allows you to upgrade the software of the receiver. This can be done from PC to receiver or from a master receiver to a slave receiver.
2.Connect master receiver or PC to the
slave receiver via serial
mode. Upgrade modes include: allcode / maincode /
3.Switch on the slave receiver.
4.Mark “Start” on the master reeciver and press [OK] to start upgrade.
Wait until the display on the front panel shows “END”. Then switch off the receiver and on again. Now the new software is used.
5.Press [MENU] to save the setting without upgrade.
34
