Manuals / Brands / Marine Equipment / Marine GPS System / Trimble Outdoors / Marine Equipment / Marine GPS System

Trimble Outdoors 64057-00-ENG Command Packet 0x8E-A8 Type 2 Data Format, Command Packet 0x8E-A8 Type 3 Data Format

1 88

Download 88 pages, 1.13 Mb

Trimble ThunderBolt E GPS Disciplined Clock User Guide 73

Trimble Standard Interface Protocol A

Command Packet 0x8E-A8 Type 2 Data Format

Command Packet 0x8E-A8 Type 3 Data Format

Command Packet 0x8E-A9: Self-Survey ParametersUse command packet 8E-A9 to set the self-survey parameters or to request the current settings. The re ceiver replie s to requests w ith response packet 8F-A9.

Byte Item Type Description

0 Subcode UINT8 0xA8

1 Type UINT8 2 = recovery mode parameters

2-5 Jam Sync Threshold Single nanoseconds

6-9 Maximum Frequency Offset Single ppb (parts per billion or 1x10-9)

Byte Item Type Description

0 Subcode UINT8 0xA8

1 Type UINT8 3 = initial DAC voltage

2-5 Initial DAC voltage Single Volts

Data field Description

Self-Survey Enable Use this field to enabled or disabled the self-survey mechanism.

0: Disable the self-survey mechanism

1: Enable the self-survey mechanism

Position Save Flag Use this field to tell the self-survey mechanism to automatically save (or

to not save) the self-surveyed position at the end of the self-survey

procedure. This flag also determines how the The receiver will respond

to the saved position it is using for Over-Determined Clock Mode when

the position appears questionable (i.e. if the position may off by a

large amount.) If the flag is set to 0, then a questionable position will

be flagged in packet 0x8F-AC. If the flag is set to 1, then a questionable

position will automatically be deleted.

0: Don't automatically save the surveyed position when self-survey is

complete

1: Automatically save the surveyed position when self-survey is

complete.

Self-Survey Length Use this field to specify the number of position fixes that are to be

averaged together to form the self-surveyed position used for clock-

only fixes. Limits: 1 to (232 - 1) fixes.

Contents

Main Page USER GUIDE 2 Trimble ThunderBolt E GPS Disciplined Clock User Guide Trimble ThunderBolt E GPS Disciplined Clock User Guide 3 Page Safety Information Warnings and Cautions C Operation and storage C AC adaptor safety An international adaptor kit is provided with the ThunderBolt E GPS disciplined clock. Contents 2 Setting up and Running the ThunderBolt E . . . . . . . . . . . . . . . . . . 13 Page Introduction Operation Features Hardware features Interface protocols Standard timing software features C Technical assistance Your comments Page Setting up and Running the ThunderBolt E System requirements Hardware Computer System software Installing and using the software B Trimble GPS Monitor C Page TSIP Page Page ThunderBolt E starter kit Setting up the ThunderBolt E Page Hardware Integration ThunderBolt E system architecture ThunderBolt E module Environmental specifications Trimble ThunderBolt E GPS Disciplined Clock User Guide 25 Hardware Integration 3 C Page Bullet antenna specifications Physical characteristics Environmental specifications Antenna cable Page I/O connector pin-out Power supply and connector Page Firmware Integration Firmware configuration Firmware upgrades Firmware features APPENDIX A Trimble Standard Interface Pr otocol Introduction Interface scope Automatic output packets Customizing operations parameters 36 Trimble ThunderBolt E GPS Disciplined Clock User Guide Packet I/O control (segment 4) Serial port configuration (segment 5) Accurate position (segment 7) Timing outputs (segment 6) Trimble ThunderBolt E GPS Disciplined Clock User Guide 37 Packets output at power-up Command packets: User to ThunderBolt E The following table summarizes the packets that can be sent to the ThunderBolt E by the user: 38 Trimble ThunderBolt E GPS Disciplined Clock User Guide Report packets: ThunderBolt E to User The following table summarizes the packets output by ThunderBolt E: Trimble ThunderBolt E GPS Disciplined Clock User Guide 39 Packet structure Packet descriptions Packet descriptions used in run mode Page Page Page Page 46 Trimble ThunderBolt E GPS Disciplined Clock User Guide Page Page Page Page C Page Page 54 Trimble ThunderBolt E GPS Disciplined Clock User Guide Report Packet 0x58 Almanac Data Type 2 Note All angles are in radians. Report Packet 0x58 Ionosphere Data Type 4 Report Packet 0x58 Almanac Health Data Type 3 Trimble ThunderBolt E GPS Disciplined Clock User Guide 55 Report Packet 0 x 58 UTC Data Type 5 (continued) Report Packet 0 x 58 Ephemeris Data Type 5 Page Page 58 Trimble ThunderBolt E GPS Disciplined Clock User Guide Page Page C 62 Trimble ThunderBolt E GPS Disciplined Clock User Guide Command Packet 0xBB Data Format (query only) Report Packet 0xBB Data Format C TSIP Superpackets Page Page Page Page Trimble ThunderBolt E GPS Disciplined Clock User Guide 69 Command Packet 0x8E-A4 Test Mode 0 Data Format Command Packet 0x8E-A4 Test 1 Mode 1Data Format Command Packet 0x8E-A4 Test Mode 3 Data Format Page Page 72 Trimble ThunderBolt E GPS Disciplined Clock User Guide Command Packet 0x8E-A8 Type 0 Data Format Command Packet 0x8E-A8 Type 1 Data Format Trimble ThunderBolt E GPS Disciplined Clock User Guide 73 Command Packet 0x8E-A8 Type 2 Data Format Command Packet 0x8E-A8 Type 3 Data Format 74 Trimble ThunderBolt E GPS Disciplined Clock User Guide Command Packet 8E-A9 Data Format Command Packet 0x8E-AB Data Format Page Page Page Page Page 80 Trimble ThunderBolt E GPS Disciplined Clock User Guide Report Packet 0x8F-AC Trimble ThunderBolt E GPS Disciplined Clock User Guide 81 82 Trimble ThunderBolt E GPS Disciplined Clock User Guide Page Page Page www.trimble.com