Troy-Bilt 630CN manual Install Forward, Clutch Cable

	Fig. 2=3: Wheel in FREEWHEELposition
	STEP 4: INSTALL FORWARD
	CLUTCH CABLE
	1. Attach the forward clutch cable bracket
	(P, Fig. 2-4) to the handlebarsupport AI
	with a 1/4"-20 x 1-1/4" hex hd. screw (R)
	and 1/4"-20 hex Iocknut (S). Tighten se-
	curely.
	2. Carefully unwrap the forward clutch ca-
	ble (cable without anattached knob, from
	its shipping position and slide the thin ca-
	ble wire (T,Fig. 2-4) into the slot in the ca-
	ble bracket. Push the cable connector (U,
	Fig. 2-4) upthrough the holein the bracket
	until the groove in the connector snaps
	into place.
	3. Insert the #10-24 x 2" slotted hd. screw
	(V, Fig. 2-5) down through the hookedend
Fig.2.2: Atlachhandlebar(5.5 HpMOde!shown),	of the cable spring (W) until the screw
	threads extendthr0ugh the spring.
2. Removethe hairpin cotter (L, Fig. 2-3)
and wheel drive pin (M) from the wheel
hub (0) and wheel shaft (N).
3. Slidethe wheelfully inward onthe wheel
shaft (N, Fig. 2-3). Reinstall the wheel
drive pin (M) through the wheel shaft only
(not through the wheel hub). Securethe
wheel drive pin with the hairpin cotter (L),
pushing the hairpincotter in asfar as it will
go. The wheel should now spin freely
(freewheel) on the wheel shaft. Repeat
with the other wheel.
4. Usethe handlebarto roll the tiller to a
flat area.

IMPORTANT: Before Startingthe engine,

the wheels must be placedin the WHEEL Fig.2-4. Installingforwardclutchcablebracketandcable. DRIVEposition (pins through wheel hubs

andwheel shaft). This procedure is described in WheelDrive Pins in Section3.