Tunturi C6 owner manual I N T E N a N C E, A N S P O R T a N D S T O R a G E, M E N S I O N S

with the elastic belt, firmly enough so that the electrodes remain in contact with the skin while pedaling, but not so tight that normal breathing is prevented. If you wear the transmitter and belt over a light shirt, moisten the shirt slightly at the points where the electrodes touch the shirt. The transmitter automatically transmits the heart-rate reading to the meter up to a distance of about

1 meter. The heart-rate value is displayed in the meter. Follow your heart rate during the training.

REMARKS ON TELEMETRIC

MEASUREMENT

If the electrode surfaces are not moist, the heart rate reading will not appear on the display. If the electrodes are dry, they must be moistened again.

Allow the electrodes to warm up properly to ensure accurate heart-rate measurement. If there are several telemetric heart rate measurement devices next to each other, the distance between them should be at least 1.5 m. Similarly, if there is only one receiver and several transmitters in use, only one person with a transmitter should be within transmission range. The transmitter is switched to an active state only when it is being used for measurement. Sweat and other moisture can, however, keep the transmitter in an active state and waste battery energy. Therefore it is important to dry the electrodes carefully after use.

When selecting training attire, please note that some fibers used in clothes (e.g. polyester, polyamide) create static electricity which may prevent reliable heart rate measurement.

Please note that a mobile phone, television and other electrical appliances form an electro-magnetic field around them which will cause problems in heart rate measurement.

ERROR CODES

The user interface will display information about operational faults. An error code begins with the abbreviation Err.

ERR 1 Speed sensor problem

ERR 2 Data communication problem

Remove the power cord from the power outlet, wait for 1 minute and then restart. If the error message does not disappear, please contact your Tunturi dealer.

G B

O W N E R ' S M A N U A L • C 6

M A I N T E N A N C E

The equipment requires very little maintenance. Check, however, from time to time that all screws and nuts are tight. Clean the equipment with a damp cloth. Do not use solvents.

NOTE! Never remove the protective covers.

NOTE! The brake forms a magnetic field which may damage the mechanism of a watch or the magnetic identification tape of a credit or cash card if they come into immediate contact with the magnets. Never attempt to detach or remove the magnet of the magnetic brake.

If you notice a malfunction during use, contact the dealer. Always give the model and serial number of your device, please state also the nature of the problem conditions of use and purchase date. In spite of continuous quality control, individual defects and malfunctions may occur in individual components. It is in most cases unnecessary to take the whole equipment for repair, as it is usually sufficient to replace the defective part.

T R A N S P O R T A N D S T O R A G E

The device is easy to move by pushing along on the integrated transport wheels. Tilt the device from the front and push along the floor on the wheels at the front support.

To prevent malfunctioning of the equipment, store in a dry place with as little temperature variation as possible, protected from dust.

D I M E N S I O N S
Length	130cm
Width	61 cm
Height	156 cm
Weight	73 kg

All Tunturi models are designed to meet the electromagnetic compatibility directive, EMC and are affixed with the CE conformity marking. User safety of Tunturi products is tested, and are affixed with the TÜV-marking.

NOTE! The instructions must be followed carefully in the assembly, use and maintenance of your equipment. The warranty does not cover damage due to negligence of the assembly, adjustment and maintenance instructions described herein. Changes or modifications not expressly approved by Tunturi Oy Ltd will void the user’s authority to operate the equipment!

Due to our continuous policy of product development we reserve the right to change specifications without notice.

7