SEAT
Loosentheseatholderlockingscrewandturntheupper locking lever so that it is aligned with the equipment. Place the seat into position on the grooves of the lower locking lever.Turn the upper locking lever towards the top of the seat rails and lock the seat by tightening the locking screw.
POWER CORD
Plug the socket end of the transformer cord into the connector, just above the rear support in the centre of the frame, and the other end into the wall socket. To preventdamagetotheconnector,werecommendyou tiethecordtothetransportationwheelsupportnextto the connector.
Always remove the mains cable from the fitness equipment first, and only then remove it from the power source. Always connect the mains cable to the power source first, and only then connect it to the fitnessequipment.Invertedorderresetsthemeterclock display.
Behindtheconsolethereisabatterycase.Thecyclecan be used with batteries or with electric current. If the deviceisusedsolelywithbatteries,pleasenotethatthe servobrakesexhaustthebatteriesratherquickly.Hence, werecommendtheuseofelectricityasthemainpower source.
The clock in the console uses always batteries, even whenthedeviceisnotconnectedtoanypowersource. Otherwise the clock would reset to zero.
O w n e r ’ s m a n u a l • E 2 5 GB
NOTE!
The device must be connected to a grounded wall socket. Do not use extension wires when connecting the device to the power source. Make sure the power cord does not run underneath the device.
Always switch off the power and uplug this appliance from the electrical outlet immediately after using.
ADJUSTMENTS
Set the right height for you; the basic rule is that the arch of the foot reaches reaches the the pedal at its lowest point with the leg almost straight. Adjust the seatheightbylooseningtheseatlockingknob.Holdon to the seat with one hand and, using your other hand, pull the locking knob outwards in order to enable free seattubemovementupwardsanddownwards.Oncethe height is right, let go of the knob and the seat locks into place. Turn the locking knob clockwise to tighten.
NOTE! Always make sure that the locking knob is properly fastened before starting to exercise!
Toadjustthehorizontalseatpositionforwardandback, loosen the locking screws under the seat. You can also adjust inclination from here. Release the seat lock by turning the locking lever located under the seat anti- clockwise. Adjust the seat to the desired position and tighten the locking lever by turning it clockwise.
HANDLEBAR SETUP
Loosenthelockingscrewsonthefrontofthehandlebar support and find the right angle at which to position thehandlebar.Tightenthelockingscrews.Thedesignof thehandlebarallowsyoutoexerciseeitherinanupright position or with the upper body leaning forward.
Remember,however,alwaystokeepyourbackstraight.
CONSOLE INCLINATION ADJUSTMENT
Settheinclinationofthemetersothatitcorrespondsto your height and exercise position.
ADJUSTMENT OF SUPPORT FEET
If the equipment is not stable, adjust the adjustment screws below the support feet as necessary.
EXERCISING
Working out with this device is excellent aerobic exercise,theprinciplebeingthattheexerciseshouldbe suitably light, but of long duration. Aerobic exercise is based on improving the body’s maximum oxygen upteke, which in turn improves endurance and fitness. The ability of the body to burn fat as a fuel is directly dependent on its
