Turbo Chef Technologies 2020 HIGH h manual Issue, Possible Causes, Resolution

1 6 T R O U B L E S H O OT I N G

Issue	Possible Cause(s)		Resolution
No power to oven.	-	Oven is not plugged in.	-	Plug oven in.
	- Main circuit breaker is		- Verify wall circuit breaker is on. Reset breaker
		tripped.		and then power oven back on.
Oven is not warm-	-	Oven is in the off state.	- Select a cooking profile.
ing up properly.	- Oven has been switched off at		- Press the back/off key until the oven is in the
		the main circuit breaker.		off state – leave for two minutes. Unplug the
				oven – leave for two minutes. Re-plug in the
				oven, switch on the isolator/main power supply
				and select a cooking profile.
	- Problem with the heater.		-	Call customer service.
Oven is not cook-	-	Oven is not clean.	- Clean the oven following the weekly cleaning
ing properly				instructions on pages 5-7.
	- Incorrect cooking profile or		- Ensure that the correct cooking profile is
		belt speed was selected for the		selected for the product.
		product.	- Ensure product is in the correct state before
	- Product was not cooked from			being placed in the oven.
		correct starting state, e.g.
		chilled, frozen, etc.
F1: Blower Failure	-	Oven power interrupted.	- Verify wall circuit breaker is on. Reset breaker
				and then power the oven back on. Press the
				back/off key until the oven is in the off mode –
				leave for two minutes. Unplug the oven – leave
				for two minutes. Re-plug in the oven, switch
				on the isolator/main power supply and select a
				cooking profile.
F2: Low Temp	-	Oven power interrupted.	- Verify wall circuit breaker is on. Reset breaker
During Cook				and then power oven back on.
	-	Excessive load.	-	Reduce load.
	- Oven is not clean.		- Clean the oven following the weekly cleaning
				instructions on pages 5-7.
	- Oven not fully warmed up.		- Press the back/off key until oven returns to the
				oven off mode. Re-select the cooking profile
				and allow oven to reheat.
	-	Defective heater.	-	Call customer service.
	- Blower motor not running.		-	Call customer service.
	-	Low supply voltage.	- Call electrician to improve power supply.