Viewing the Fault Log
From the INFO MODE (Figure 20), press the R3 soft key to view the fault log (Figure 22). To view a detailed log of each fault occurrence (Figure 23), press the soft key adjacent to the fault code.
Viewing the Service Numbers
From the INFO MODE (Figure 20), press the R4 soft key to view technical support contact info.
Turning Oven Options On/Off
From screen 2 of the INFO MODE (Figure 21), press the L2 soft key to access the “Options” screen (Figure 24). When prompted, enter the password 9 4 2 8 and press the Enter key.
From the “Options” screen, the following oven options can be turned on or off:
-“Adjust Time” screen (page 12 for more details)
-“Cook More” (Additional Cooking Options) screen (page 13 for more details)
-Edit Mode (page 17 for more details)
-“Load Menu” screen (see adjacent for more details)
-Demo Mode (TurboChef use only)
-DHCP (TurboChef use only)
Setting the Date/Time
Having an accurate date and time is important for logging oven counts, diagnostics, and fault conditions, should any occur. The oven time and date are set at the time of manufacture; however, the operator may at some point be required to make an adjustment.
From screen 2 of the INFO MODE (Figure 21), press the L4 soft key to access the “Set Date/Time” screen (Figure 25).
To set the date and time,
1.Use the L3 and R3 soft keys (middle left and middle right) to navigate between fields.
2.Use the numeric keypad to enter the month, day, and year, followed by the hour and minute.
NOTE: The clock is a
3.Select “Save” to save your changes or “Cancel” to cancel and exit the screen.
NOTE: The oven will not retain the time if it is left unplugged for two or more weeks.
Resetting the Oven
Resetting the oven is one way to potentially clear an error message, should one occur. From the “Cooling Down” or “Oven Off” screen, press and hold the Info key for five seconds.
Updating the Oven Menu
From screen 2 of the INFO MODE (Figure 21, page 14), press the R1 soft key to access the “Load Menu” screen (Figure 27, page 16).
NOTE: This feature can be turned on or off via the “Options” screen (Figure 24).
To load a menu to the oven via smart card,
1.Insert the smart card (Figure 26, page 16).
2.Press the L1 soft key (Figure 27, page 16).
3.Verify the oven beeps and reads “FINISHED” (Figure 28, page 16).
To load a menu via USB drive,
1.Verify the menu on the USB drive is named MENU.BIN.
2.Verify the menu on the USB drive is in a folder named TC_MENUS. This folder must not be a
3.Insert the USB drive (Figure 26, page 16).
4.Press the L4 soft key (Figure 27, page 16).
5.Verify the oven beeps and reads “FINISHED”.
15
THE INFO MODE
