Tyan Computer S5375 Installing the Power Supply, Finishing up, Applying power to the board

2.11 - Installing the Power Supply

There are two power connectors on your Tempest i5100X S5375. The Tempest i5100X S5375 requires 2 power inputs.

-24-pin (PW1)

-8-pin (PW2)

NOTE: Please be aware that ATX 2.x, ATX12V and ATXGES power supplies may not be compatible with the board and can damage the motherboard and/or CPU(s).

1 x 24-pin 12V Power Connector

1 x 8-pin 12V Power Connector

1 x 4-pin 12V/5V Power Connector (PW3, aux. power supply for TYAN Riser Card M2061)

Applying power to the board:

1.Connect the 12V 8-pin power connector.

2.Connect the EPS/12V 24-pin power connector.

3.Connect the 4-pin aux. power connector for TYAN Riser Card M2061.

4.Connect power cable to power supply and power outlet.

NOTE

YOU MUST unplug the power supply before plugging the power cables to motherboard connectors.

2.12 - Finishing up

Congratulations on making it this far! You’re finished setting up the hardware aspect of your computer. Before closing up your chassis, make sure that all cables and wires are connected properly, especially IDE cables and most importantly, jumpers. You may have difficulty powering on your system if the motherboard jumpers are not set correctly.

In the rare circumstance that you have experienced difficulty, you can find help by asking your vendor for assistance. If they are not available for assistance, please find setup information and documentation online at our website or by calling your vendor’s support line.

30