http://www.tyan.com
28
Figure 2-16 secure module here
Line up the retention brace with the holes provided on the motherboard. At
the same time, make sure the CPU is lined up with the CPU slot. Lower the
CPU onto the motherboard. The mountings on the retention brace should fit
through the holes of the motherboard and the CPU should fit into the slot.
See Figure 2-15). Secure the retention brace. The end result should look like
Figure 2-16.
Chapter 2
Board Installation
Figure 2-15
Note: The retention module shown above may not represent the one
provided with your motherboard.