12.Fasten upper hinge to unit (three screws) (Figure 29). Partially tighten screws.
13.Adjust door to assure proper seal. Tighten upper and lower hinge screws securely.
14.Replace three plastic plugs removed in Step 10 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.
15.Replace the grille and grille cap. Be sure to place grille cap on opposite side of unit from where it was originally.
Black or White Model 1175R
To reverse the door, perform the following:
1. Remove the grille (two screws).
ULIN_0104_A
Figure 30
2.Remove top hinge from cabinet (four screws) (Figure 30). Hold door to keep it from falling.
3.Lift the door off the bottom hinge.
ULIN_0105_A |
Figure 31
4.Remove four plastic plugs (Figure 31) in hinge holes, top of cabinet, opposite side. Be careful not to scratch cabinet.
| Hinge |
|
Plastic |
| Plastic |
Plug Hole |
| Plug Hole |
| Screw |
|
Right Side |
| Left Side |
Door Swing |
| Door Swing |
Right Side | Invert | Invert |
Hinge | Screw | Hinge |
|
| ULIN_0106_A |
Figure 32
5.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge (Figure 32). Do not install hinge on cabinet at this time.
ULIN_0107_A |
Figure 33
6.Remove bottom hinge from cabinet (four screws) and screws on opposite side of cabinet (Figure 33).
7.Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge (Figure 32).
ULIN_0160_A |
Figure 34
8.Install bottom hinge on cabinet, opposite side, aligning flat edge of hinge with outer edge of unit (Figure 34). Partially tighten screws.
18 | 1115R, 1175R, 29R, 1175BEV |
