U-Line manual Model 29R, 1115R, 1175R, 29R, 1175BEV

1

ULIN_0109_A

Figure 35

9.Relocate plastic spacer/bushing (Figure 35) on bottom of door to the opposite side. Clean out bushing hole in door bottom if necessary.

ULIN_0110_A

Figure 36

10.Place door on lower hinge pin. Align flat edge of top hinge with outer edge of unit and fasten upper hinge to unit (four screws) (Figure 36). Partially tighten screws until door is aligned.

11.Adjust door to assure proper seal. Tighten upper and lower hinge screws securely.

12.Replace four plastic plugs removed in Step 4 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.

13.Replace the grille.

Model 29R

To reverse the door, perform the following:

2

1

ULIN_0197_A

Figure 37

1.Remove the control knob (Figure 37, 1) by pulling it straight out, away from grille.

2.Remove two screws from grille (Figure 37, 2) and save.

3.Remove the grille and grille cap from unit.

ULIN_0143_A

Figure 38

4.Remove top hinge from cabinet (three screws) (Figure 38). Hold door to keep it from falling.

5.Lift the door off the bottom hinge.

ULIN_0121_A

Figure 39

6.Remove bottom hinge from cabinet (two screws) (Figure 39).

1115R, 1175R, 29R, 1175BEV 19