U-Line 29R Glass Shelf Removal/Installation, Light Bulb Replacement, 1115R, 1175R and 1175BEV

Glass Shelf Removal/Installation

1

ULIN_0199_A

Figure 48

For Models 29R and 1175BEV (Model 29R illustrated above), reposition the shelves as follows:

1.Open door completely.

2.Grasp the shelf edge in the center (Figure 48, 1), and slide the shelf from the unit.

3.Reposition the shelf as required, ensuring the raised white edge strip is toward the rear of the unit and the decorative graphics, if applied, are on the underside of the shelves.

IMPORTANT

•Make sure the shelves are inserted fully into the unit.

•The white edge strip toward the rear prevents cans and bottles from freezing against the cold evaporator.

For all other models, reposition the shelves as follows:

3

1

2

ULIN_0066_A

Figure 49

1.Pull shelf out about 6" (Figure 49, 1), until back of shelf clears the “hump” on the right-hand side.

2.Tilt up right-hand edge of shelf (Figure 49, 2).

3.Remove shelf from unit by pulling out (Figure 49, 3). Insert the shelves as follows:

1.To move to a different position in the unit, insert shelf at an angle, approximately 15-20°, over the rib in the side of the unit where you want to place the shelf. The shelf must be started into the unit at an angle to clear the door.

2.Continue to slide the shelf into the unit at an angle until it clears the door.

3.Lower the shelf and push it in completely.

Light Bulb Replacement

1115R, 1175R and 1175BEV

To replace the light bulb in your U-Line unit:

2

1

ULIN_0001_A

Figure 50

1.Grasp the edges of the light housing lens

(Figure 50, 1) opposite the exposed tab, and gently push the lens towards the tab (Figure 50, 2).

2.Pull the edge of the lens down (Figure 50, 1), and swing it out of the light housing.

IMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N 31317) in the light housing. Use of any other bulb within the housing will generate excessive heat, causing damage to the light housing and cabinet interior, and compromising the precise temperature control of your unit.

3.Replace the bulb only with a genuine U-Line P/N 31317 replacement.

4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.

22 1115R, 1175R, 29R, 1175BEV