Manuals / Uniden / Kitchen Appliance / Cooktop

Uniden BC 278CLT manual Set Alarm to Radio Mode, Turn the Alarm Off

Models: BC 278CLT

1 44

Download 44 pages 28.43 Kb

Page 37

Set Alarm to Radio Mode

Set Alarm to Radio Mode

Before you set the Radio Alarm, make sure an AM or FM channel has been selected and the VOLUME control is set to the desired level.

You must be in Clock mode(scanner off) to be woken up by the radio alarm.

1.Press OFF.

2.Press and hold ALARM for more

than 2 seconds. When the alarm is on, the ALARM and RADIO icons flash for 5 seconds.

3. The ALARM remains on.

When the alarm goes off, it will play the radio station that was previously selected. The alarm will continue for approximately 15 minutes, if no action is taken.

Snooze function

To silence the alarm, simply press any key. This silences the alarm for about nine minutes. You can repeat this cycle for over an hour.

Turn the Alarm Off

Press ALARM to turn the alarm off. When the alarm is off, the ALARM icon and current alarm time are no longer displayed, only the current time is displayed.

34

Image 37

Uniden BC 278CLT manual Set Alarm to Radio Mode, Turn the Alarm Off

Contents

CHANNEL LOCKOUT PRIORITY CHANNEL SCAN DELAY ALARM CLOCK AM/FM RADIO SERVICE SCANMEMORY BACKUP BC 278CLTPrecautions Set-Up Using the Scanner Additional Features TABLE OF CONTENTSAbout the Unit Troubleshooting SpecificationsAbout Scanning INTRODUCTIONUnpacking Taking Proper Care of Your ScannerGETTING STARTED Installing the BC278CLTOPERATION VOLUMEControls and Functions SQUELCH21 SCAN Key ALARM AM,FM Scanning OverviewChannel Initial Clock Set-up CLOCK SET-UPSet the Squelch USING THE SCANNER4.To set the SQUELCH control to AUTO turn fully counterclockwise until control clicks into place. Or, manually set squelch as follows Programming Tips for scanner Programming Scanner Frequencies Deleting a Scanner Frequency Scanning Mode About Memory Back-upBank Scanning The following screen appearsManual Mode Priority Scanning Direct Channel AccessExample To set Channel 5 as the priority channel To Set the Priority Channel1. Press MANUAL to exit the Scan Mode 3. Press and hold PRIORITYChannel Lockout Delay Restore All Locked Out Channels1. Press MANUAL To Set Delay in Manual Mode To Set Delay in Scan Mode2.Select the channel you want using your keypad 1. Press SCANSearching 1. Press HOLD or LIMIT at any time to Search Hold modestop the search Storing Search FrequenciesWeather Channel Service ScanSCANNER, RADIO AM/FM or OFF To exit Weather Channel Scan mode, pressTo cancel the siren, press WX/ALERT Weather Alert with S.A.M.EProgramming FIPS Code About S.A.M.ELCD Backlight ADDITIONAL FEATURESProgramming Radio AM/FM Frequencies 4. Press E to complete the entry. The channel digits stop flashing Deleting a Stored Radio Frequency Direct Channel Access for Radio StationsReset the Clock Time Set the Alarm Time Set Alarm to Tone Mode Turn the Alarm Off Turn the Alarm Off Set Alarm to Radio ModeHelpful Hints ABOUT THE UNITProblem TROUBLESHOOTINGSolution Problem At Uniden, we’ll take care of youSolution Adjust squelch to the threshold PageAbove bands in 5 kHz steps TECHNICAL SPECIFICATIONSAbove bands in 5 kHz steps Above bands in 12.5 kHz stepsPage ONE-YEAREXTENDED WARRANTY 1999 Uniden America Corporation UBZZ01304ZZ THANK YOU