51
Remote access away from home
You can operate your answering system from a remote location
using any touch-tone telephone. Use this function to check for
recorded messages, to play or delete messages, even to record a
new outgoing message, and to monitor sounds in the room.
Prior to accessing the system remotely, you must have selected a
PIN code (refer to page 45).
1Call your telephone number.
2While the answering machine is activated, press #and your
PIN code.
3The answering system announces the time and day and the
number of messages stored in memory. Then the message
playback automatically begins.
4You may continue to listen to your message, or you may
select a command from the following chart.
Command Function
# then 1Repeat
# then 2Playing your messages
# then 3Skipping a message
# then 4Deleting a message
# then 5Stop message playback
# then 6Answering system on
# then 7Voice memo record/stop
# then 8Outgoing message record/stop
# then 9Answer system off
# then Room monitor
5After all of your messages have played, or the playback time
exceeds 4 minutes, you will hear intermittent tones indicating
that the system is in the command waiting mode. You may
enter another command at this time from the chart above.
6When you are finished, hang up to exit the system.
The answering system automatically returns to standby.
*You must enter a
command within 15
seconds of entering
command waiting mode
or the answering system
automatically hangs up
and returns to standby.
During the remote
operation, rCdisplays
on the base.
The system will only
playback messages for
four minutes and then it
returns to command
waiting mode. To continue
playing your message,
press #then 2again
within 15 seconds
EXAI985HS 10/10/00 10:15 Page 51