Uniden EXI 386 Series manual Terminology, Direct wall mounting

Direct wall mounting

If you don't have a standard wall plate, you can mount your phone directly to the wall. Before doing this, consider the following:

•Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall.

•Try to mount your phone within 5 feet of a working phone jack to avoid excessive lengths.

•Make sure the wall material is capable of supporting the weight of the base and handset.

•Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall material where the base unit will be placed.

1) Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/16 inches apart. Allow about 1/8 of an inch between the wall and screw heads for mounting the phone.

2) Refer to steps 1 through 6 on pages 12 to mount the telephone.

Terminology

Throughout this manual, terms such as Standby and Talk Mode are used. Below is the terminology explanation.

•Standby Mode - The handset is not in use. It may be in the cradle, or it may be out of the cradle but talk/flash has not been pressed.

•Talk Mode - The handset is off the base and talk/flash has been pressed, enabling a dial tone.

G E T T I N G S T A R T E D [ 13 ]

GETTING STARTED