
I
Setup
The USC 120XLT comes with a rechargeable | ||||
Battery Pack. When | fully charged, this Battery | Pack | will | |
supply | up to 12 hours | of dependable use. (With the | Squelch | |
control | in "closed" position.) |
| I |
Before using the USC 120XL T for the first time, or whenever the LOW BATTERY Indicator appears on the LCD display, you should fully charge the Battery Pack.
Note: When the Battery Pack is Iow, the Low Battery Indicator will start to blink. After about 10 minutes, the
scanner will shut itself off to prevent the battery from becoming completely discharged.
Before charging, you must first install the Battery Pack according to the steps below.
Charging the Battery Pack
1.Plug the AC Adaptor/Charger
Charging Jack located on the Left side of the
UBC 120XLT . (You can use the scanner while it is charging.)
WARNING! Use only an
Charger, (or one of the optional Cigarette Lighter Power Cords listed on page 26). Any
other AC Adaptor or external cord or power plug
having
cause overheating or damage to the
2.Plug the AC Adaptor/Charger into a standard AC outlet.
To fully charge the battery, leave the Adaptor/Charger connected for 14 to 16 hours.
3.When charging is complete, disconnect the Adaptor! Charger from the AC outlet and from the Battery Pack.
Note: Disconnect the AC Adaptor/Charger from the unit during a power failure.
Mounting the Flexible Antenna
Place the end of the antenna onto the BNC connector on top of the scanner and turn clockwise until tight.
10