Programming Channels
Before you can scan, you must program the channels within a bank. You can store one frequency per channel, up to 100 channels.
Note: If appears on the display (keypad Locked), unlock the keypad by pressing and holding (LocK)until
disappears and you hear two beeps.
There are two ways to program a channel:
. | Manually select | a channel and frequency, | using the | |
| numeric | keypad. |
| |
. | Search | a band | to find an active frequency, | and then |
| directly | store it | into a selected channel. (See the | |
| Search | section, | page 21.) |
|
Programming By Manual Entry
1.Selecta frequency.
Example: Program 125.2500 MHz into Channel 18.
2.Make sure the scanner is in the SCAN Mode. If it is in
the SRCH Mode, press @.
3.Press ~ to stop scanning.
4.Press CDQ)@ to go to Channel 18.
5.Enter the frequency number using the numeric keypad. (Be sure to include the decimal point.) As soon as you enter the first digit of the frequency, the channel number begins ,to blink.
eD CD CD 0 CD CD.
BANK \ ~I
-:lB~725.2500
I 1\ HOLD
If you make a mistake and want to clear the entry, press 0 twice and
14
