Side Controls and Connectors | Uniden UH-057 instruction

,

MONITOR SWitch

PTT

(Push-to- Talk)

Switch

TX POWER HI/LO

Switch

Battery Pack

Release Button

Side Controls and Connectors

Battery Pack Release Button - To remove the Battery Pack, push up on the release button and slide the Battery Pack away from the radio.

Monitor Switch - Press to set the Auto-squelch feature ON or OFF.

Push-to- Talk (PTT) Switch - Press and hold to talk.

: Release to listen for a reply.

i TX Power HI/LOW Switch -Press to set the Transmit

output power to HIGH (5W) or LOW (1W).

AC Adaptor/Charger Jack - Connect AC Adaptor/Charger here

Page 9

UH-O57

"

Image 11

Uniden UH-057 manual Side Controls and Connectors, TX Power HI/LOW Switch -Press to set the Transmit

Contents

UnidenSUNDOWN ERUH-57 Uniden~ is a registered trademark of Uniden Corporation Nickel-Cadmium Battery Warning Table of Contents Selcall 3UH-O57 Descrl ptlonUlrements Feature Highlights UH-O5J UH-O57 Belt Clip Wrist strap Locks out a selected channel from channel scan Top Indicators and Display ~~88 AC Adaptor/Charger Jack Connect AC Adaptor/Charger here Side Controls and ConnectorsTX Power HI/LOW Switch -Press to set the Transmit Built-in Speaker Audio Output Front Controls RX ID, TX ID, or lead-In tone Enter lead-In Delay ProgrammingUH-O57 Hash Key Press and hold for 1.5 sec to Channel Enter Key Press to enter the selected Getting Started Antenna Battery Information Belt Clip Installation Recharging the Nickel-Cadmium Battery Pack Operation To resume scanning, press the 0 Key Channel Scan Press D PriorityScanning is inactive in TSO Scan Mode Create a Channel Scan List with Channel Lock-Out Feature Transmit Maximum transmit power output level of UH-O57is 5 watts Display Low Battery Level DetectionButton. DUP indicator appears on the LCD Display Special Feature Example Choosing CH20 as your Call Channel Puts the receiver on Quiet Mode also known as ToneRequired Selcallid to open the Quiet condition is received Tone Squelch Scanning When a call is received Key Cancel TSQ Scanning by pressing either the 0 orUsing the 0 or 0 Key, browse through the TSQ Channels When a Selcall is received, press the PIT Switch Radios Tone CallingTX Selcall ID Format 3 4 D Receiver Selcall ID CD 1ADJ Press the @ Key Transmitter Selcall ID TcAL Programming MSec Other SELCALLParameters Lead-In Delay Sec Lead-In ToneKey LCD Display To remove the lead-In Tone Select the lead-In Tone you want to use Example Programming Guide Delay S Page35UH-O57 Care and Maintenance Princess Highway, Rockdale, NSW Service UHF CB Channel Information Duplex Operating Mode Simplex Operating Mode Buttons Channels Transm itter Warranty UTZZO1857ZZ