MAC Address:
Displays the Ethernet MAC address of the LAN (Ethernet) interface of the WNP1000 Wireless AP. You may not change the MAC address of your WNP1000 Wireless AP.
Change the following fields as desired, and then click Apply. Please remember that changes will not take effect until after the WNP1000 Wireless AP is restarted.
LAN IP Address:
In this field, you enter the IP Address of the WNP1000 Wireless AP’s LAN port. If you change this address from the factory default of 192.168.1.10, please remember the new address, as you will need to use it to access the WNP1000 Wireless AP for configuration in the future. However, if you forget the IP Address you can press the Reset button located on the bottom of the WNP1000 Wireless AP. Push and holding the Reset Button for three seconds restores all settings to the factory default settings.
Subnet Mask:
In this field, you enter the Subnet Mask of the local network to which the WNP1000 Wireless AP is attached. The default Subnet Mask is 255.255.255.0.
Reset Button
If you change the IP address of the WNP1000 Wireless AP and forget the IP address, you can reset the access point back to the factory default settings, 192.168.1.10.
Press and hold the Reset Button for three seconds with the end of a paper clip, while the access point is ON. The access point will then restore the unit to the original factory settings. The Reset Button is located on the bottom of the WNP1000 Wireless AP.
Note: All settings you entered for the SSID, WEP, User Name and Password will be erased and you will need to re- configure the unit to your settings.
Pressing the Reset Button once will is a soft boot and will refresh the Access Points connections.
Reset Button
17 | 18 |
