Manual Key Entry
To manually enter the WEP keys, perform the following steps:
1.Select either 64-bitor 128-bitWEP encryption from the pull-down menu.
2.Click on Manual (Enter in the table below).
3.When WEP 64-bit is selected, type five alphanumeric characters in the range of “a-z”, “A-Z” and “0-9” (e.g. MyKey) in the WEP Key 1 entry field. Alternatively, you may enter 10 digit hexadecimal values in the range of “A-F” and “0-9” (as shown in the example below). You can also enter WEP keys in the Key 2, Key 3 and Key 4 if you wish. Select the active WEP key set (1, 2, 3, or 4) for 64-bit encryption. WEP 128-bit encryption uses only one key. Verify that you are using the same active key for all clients on your wireless network.
4.Click Apply. Remember that changes do not take effect until after you restart your WNP1000 Wireless AP by clicking the Reboot button.
