Unified Brands (2)HY-5G manual OM-HY-5G, Steam Generator and Cooking Chamber

Steam Generator and Cooking Chamber

On a regularly scheduled basis, or if the SERVICE light is on, follow the simple de-liming instructions below. This procedure should be followed for each cavity. REMEMBER: DON’T ALLOW DE-LIMING

AGENTS TO MIX WITH DE-GREASERS.

a.Ensure that the unit is turned on.

b.Set the timer to “OFF”.

c.Using a glove or towel for hand protection, carefully open the deliming port. The port may be hot, and a small amount of pressureless steam may escape as you open the port.

d.Add two cups of de-liming agent.

e.Close the deliming port cover.

f.Holding in the “CLEAN” button, press and release the ON button.

g.The clean cycle will start, and take approximately 30 minutes.

h.When the cleaning cycle is complete, the CLEANING light will flash and the unit will beep.

i.Wipe out the inside of the steamer cavity.

j.If the steamer is to be used, turn the “ON” switch on. When READY light turns on, the steamer is ready for operation, set the timer to the “ON” position.

OM-HY-5G

NOTES:

1.If the clean cycle ends abruptly, the CLEANING light will flash five times per second. This indicates that the clean cycle was aborted.

WARNING

SHOULD A CLEAN CYCLE BE INTERRUPTED, IT IS POSSIBLE THAT SOME CLEANING SOLUTION IS STILL PRESENT IN THE STEAM GENERATOR. RE-RUN THE CLEAN CYCLE AND CONFIRM THAT THE WATER IS DRAINING.

2.In the event of a power outage during a clean cycle, rerun the clean cycle when the power is restored.

3.To abort a clean cycle, turn the “ON” switch off for one second and turn it back on.

REMEMBER, DE-LIMING AGENT MAY STILL BE PRESENT IN THE STEAM GENERATOR.

If the SERVICE light is on:

1.Take the actions listed in Troubleshooting Section of this manual. Turn the steamer off for 10 seconds and then re-start.

2.Repeat steam generator cleaning cycle.

13