LOGS AND LOG STOP ASSEMBLY
LOG POSITIONING
This unit is supplied with a set of four ceramic fiber logs. wear gloves to prevent skin irritation from ceramic fibers. and water to remove any traces of fibers.
Do not handle these logs with your bare hands! Always After handling logs, wash your hands gently with soap
PROPER INSTALLATION SEQUENCE:
1.Install the rear log (#2) on the rear set of locators. Visually check to verify the log is securely placed on the locators.
2.Install the front log (#1) on the front locators. Visually check to verify the log is securely placed on the locators.
3.Install the left and right cross twigs as illustrated, on the locator pins provided in the front and rear logs. Holes provided in the bottom of the cross twigs should allow them to seat completely over these pins.
#2 
#1
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
FIGURE 8. Log Set Assembly
WARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly situated in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater.
LOG STOP POSITIONING
This unit is also supplied with a decorative Log Stop. To install the Log Stop simply place it in front of the Front Log, resting on the Front Brace as shown in the illustration to the right.
Cross section of firebox
17
