Univex SB-900 Setting the built-in wide-flashadapter, Taking close-upswith bounce-downflash, D–31

Setting the built-in wide-flash adapter

Slowly pull out the wide-flash adapter all the way, and position it over the flash head.

Then slide the bounce card back into place inside the flash head.

•When the built-in wide-flash adapter is attached and when the camera's image area is set to FX format, the zoom position is automatically set at 12 mm,

14 mm or 17 mm, and 8 mm, 10 mm or 11 mm while setting the camera’s image area to DX format.

•To set the zoom position manually, go to custom setting and set “Zoom position

setting if the built-in wide-flash adapter is broken off accidentally” to [ON] (manual setting is available). (kC-25)

•To put the built-in wide-flash adapter back into place, lift it and push it into the flash head as far as it will go.

Taking close-ups with bounce-down flash

Camera’s control panel	Setting the camera’s exposure
	mode and metering mode.

• Set the exposure mode to Aperture-Priority Auto (A) or Manual (M).

• Set the metering mode to Matrix Metering “ ” or Center-Weighted Metering “”.

Set the SB-900’s flash mode.

Position the built-in wide- flash adapter.

Tilt the flash head down. Confirm the ready-light is on then shoot.

D–31

D

Flash modes and functions