INSTALLATION INSTRUCTIONS

IMPORTANT INFORMATION

Please read this information carefully and follow the all the instructions outlined below. This will ensure the reliable operation and long service life of your navigation radio.

Keep the packaging and operating instructions in a safe place in order to pass them on to a subsequent owner in the event of selling the unit at a later date.

AOnly trained specialists may install the unit.AObserve automotive industry quality standards.

AFire hazard! When drilling, care must be taken not to damage concealed wiring harnesses, the fuel tank and fuel lines.

ANever drill into supporting or safety-relevant body parts.

AOnly install in vehicles with 12V on-board voltage and negative earth. Risk of malfunction, damage and vehicle fire if installed in unsuitable vehicles (e. g. heavy goods vehicles, buses).

AAlways observe correct assignment of vehicle connections. Incorrect assignment of the connections may lead to damage of the unit or vehicle electrical system/electronics.

Connection in vehicles equipped with standard ISO connectors

The navigation radio may be installed without major preparation in vehicles equipped with ISO standard connectors. Some signals may have to be connected to ISO connector A (refer to “Connection overview ISO chamber A”).

For vehicles with different connection requirements, ask your dealer for special leads for a problem-free installation.

Connection in vehicles without standard ISO connectors

If no adapter leads are available for your vehicle, connect the navigation radio as described in “Electrical connections”.

Taking safety precautions, Fig. 1

ABefore starting work, disconnect the earth lead from the negative terminal of the vehicle battery in order to prevent short circuits. For this purpose, follow the vehicle manufacturer’s safety instructions (alarm system, airbag, immobiliser, etc.).

Making the electrical connections

Route all wiring with care. For wiring details, refer to the connection diagram on the back fold-out page and the following table.

Do not cut non-assigned wires. Instead, wind them together and secure to one side. They may be required for retrofitting additional functions.

English

15