SETUP
Installing SIM, SAM, and SD Cards
To replace the battery 1 | Place the NURIT 8000 face down on a soft, smooth surface, so as not to |
pack/card | damage the LCD screen. |
compartment cover |
|
Figure 5 Replacing the Battery/Card Compartment Cover
2Insert the two hinges of the battery/card compartment cover into the hinge slots on the edge of the battery/card compartment.
3Close the compartment cover and press down until the locking tab snaps into place.
4Connect the AC/DC power adapter from the electrical power outlet.
Installing SIM, | Configuration of SIM, SAM, and SD cards are model dependent. You can install | |
SAM, and SD | one SIM card, up to two SAM cards, and an SD card in the NURIT 8000 terminal, | |
| Cards | depending on the particular model. |
|
| The card compartment is shared with the battery. To gain access to the battery/ |
|
| card compartment, you must first remove the battery/card compartment door. For |
|
| information on removing and replacing the battery/card compartment door, see |
|
| Opening and Closing Battery/Card Compartment Cover. |
|
|
|
| NOTE | A SIM card must be installed when using a model of the NURIT 8000 that |
|
| |
|
| implements GSM or GPRS wireless communications technology. |
To install a SIM or a SAM card
1Remove the battery/card compartment door. See Figure 4.
2If necessary, remove the battery. See Figure 10.
3Slide the
4Lift the cardholder on its hinge to a vertical position.
5Hold the SIM/SAM card vertically, with the beveled corner at the top edge and the metallic contacts facing towards the contacts on the reader.
6Slide the card into the cardholder.
NOTE Make sure that you first slide the end closest to the chip on the card into the grooves of the holder and that the beveled corner is on the top edge of the SAM card.
NURIT 8000 INSTALLATION GUIDE | 15 |
