ENGLISH
USER MANUAL
WHEEL REMOVAL/INSTALLATION
Preliminary operations
1.Turn the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it.
2.Engage the parking brake (7, Fig. E).
3.Check that the machine cannot move with one wheel lifted (the parking brake operates only on the front wheels). If necessary keep the machine stationary by placing wedges on the wheels contacting the ground.
4.Remove the wheel according to the following procedure.
Front wheel removal/installation
5.Place a jack (1, Fig. AJ) under the relevant housing (2) on the machine side sill, in front of the wheel (3) to be removed.
6.Loosen tyre nuts before jacking.
WARNING!
The jack (1, Fig. AJ) is not part of the machine equipment. Use a suitable jack with a minimum lifting capacity of
2tons.
7.Activate the jack (1, Fig. AJ) carefully, and lift the wheel (3) until it is slightly detached from the ground.
8.Unscrew the mounting nuts and remove the wheel (3, Fig. AJ).
9.Install the wheel (3, Fig. AJ) by performing steps from 5 to 7 in the reverse order. Wheel mounting nut tightening torque: 400 N·m.
Rear wheel removal/installation
10.Place a jack (1, Fig AK) under the relevant housing (4) in the rear axle (2), near the wheel to be removed.
11.Loosen tyre nuts before jacking.
WARNING!
The jack (1, Fig. AK) is not part of the machine equipment. Use a suitable jack with a minimum lifting capacity of
2tons.
12.Activate the jack (1, Fig. AK) carefully, and lift the wheel (3) until it is slightly detached from the ground.
13.Unscrew the mounting nuts and remove the wheel (3, Fig. AK).
14.Install the wheel (3, Fig. AK) by performing steps from 9 to 11 in the reverse order. Wheel mounting nut tightening torque: 400 N·m.
FUSE REPLACEMENT
1.Engage the parking brake (7, Fig. E).
2.Turn the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it.
3.Remove the transparent cover of the fuse box (24 or 25, Fig. D) and replace the relevant fuse:
Fuse box B (24, Fig. D)
a)Hazard warning light fuse (10 A)
b)Brake light/horn fuse (10 A)
c)Left side running light fuse (10 A)
d)Right side running light fuse (10 A)
e)Low beam fuse (15 A)
f)High beam fuse (15 A)
g)Cigarette lighter fuse (20 A)
h)Free fuse holder
Fuse box A (25, Fig. D)
i)Hydraulic system oil cooler fan/skirt solenoid valve fuse (20 A)
j)Fuel solenoid valve fuse (10 A)
k)Cab blower/fl ashing light/windscreen wiper fuse (15 A)
l)Dust control system water pump fuse (10 A)
Dust control system water pump/climate control system (optional) fuse (20 A)
m)Reverse gear buzzer fuse (10 A)
n)Warning lights/glow plug control unit fuse (10 A)
o)Electric jack warning light fuse (10 A)
p)Hopper lid opening/closing electric jack fuse (15 A)
4.Install the transparent cover of the fuse box (24 or 25, Fig. D).
32
33015501(3)2008-02 A
RS 501
