ENGLISH
USER MANUAL
Problem
DRIVE PEDAL
Possible cause
Remedy
The machine moves even if the drive pedal is released
The drive pedal is misadjusted
Adjust
CAB HEATING
There is no hot air
The valve or the hot water feed hoses are | Replace | |
broken | ||
| ||
There are water leaks from the heater | Replace | |
The switch is deactivated | Activate | |
The fuse is blown | Replace | |
|
|
CAB CLIMATE CONTROL SYSTEM
There is no fresh air
The compressor does not turn because the | Adjust the tension/replace the belt | |
drive belt is loosen/broken | ||
| ||
There are gas leaks from the system | Repair the leak and integrate the gas | |
The expansion valve is faulty | Replace | |
The switch is deactivated | Activate | |
The fuse is blown | Replace | |
There is an open in the gas pressure switch | Replace | |
The relay is burnt | Replace | |
|
|
DIESEL ENGINE
When turning the ignition key, the engine does not start
The drive pedal is pressed
Do not press the drive pedal when starting the engine.
NOTE
For diesel engine complete troubleshooting, see the relevant Manual.
SCRAPPING
Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the law in force:
–Brooms
–Engine oil
–Hydraulic system oil
–Hydraulic system oil fi lters
–Plastic components
–Electrical and electronic components
NOTE
Refer to the nearest Nilfi
36
33015501(3)2008-02 A
RS 501
