Vermont Casting 2550 Unprotected Surfaces, Protected Surfaces, Encore Woodburning Stove, 2000956

Encore Woodburning Stove

Distance from the Center of the Flue Collar to the Wall in Top-Exit Installations

The information on this page is helpful in planning stove placement for top-exiting installations, particularly those in- stallations with chimneys that pass through the ceiling. However, this is not a clearance chart. Final stove clearances must adhere to the guidelines stated in the clearance chart on Page 14.

Dimensions indicated are valid for installations with either 6” or 8” flue collars.

Encore: WITHOUT Stove and Chimney Connector Heat Shields

	Unprotected Surfaces				Protected Surfaces
			Corner				Corner
Parallel Installations			Installations**	Parallel Installations			Installations**
Side (A)		Rear (B)	Corner (C)	Side (A)		Rear (B)	Corner (C)
37¹⁄₂”		27³⁄₄”	31”	21¹⁄₂”		11³⁄₄”	15”
(953 mm)		(705 mm)	(787 mm)	(546 mm)		(299 mm)	(381 mm)

A B C

*

D E F

*

ST632

*This distance, from the center of the flue collar to the front edge of the hearth, is the same for all installations on this page: 35” in the United States and 37” (940mm) in Canada.

Encore: WITH Stove and Chimney Connector Heat Shields

	Unprotected Surfaces				Protected Surfaces
			Corner				Corner
Parallel Installations			Installations**	Parallel Installations			Installations**
Side (A)		Rear (B)	Corner (C)	Side (A)		Rear (B)	Corner (C)
37¹⁄₂”		15³⁄₄”	24”	21¹⁄₂”		7³⁄₄”	14”
(953 mm)		(400 mm)	(610 mm)	(546 mm)		(197 mm)	(356 mm)

A B C

D E F

ST632a

**To locate center of flue collar for corner installation, add 7” (180mm) to the clearance distance from stove corner to wall. Mark off the resulting distance from the corner along both walls. Next, measure the same distance from these two points out from the walls. These last two measurements will meet at a point representing the center of the flue collar. Refer to the diagrams above.

2000956 17