Radiance Direct Vent /Natural Vent Gas Heater
Operation
The Radiance is shipped with the operable door front plate. The stove may be operated with the doors either open or closed. To open the front doors, insert the handle into the door latch stub and turn it to the right and up. (Fig. 44) When not in use, the handle may be stored in the handle holder on the right side of the rear
shroud. (Fig. 45)
Counterclockwise to Open
ST621 | Clockwise |
to Close |
Pilot As- sembly
ST476
Fig. 46 Pilot Assembly location.
Flame & Temperature Adjustment
For stoves equipped with HI/LO valves, flame adjust- ment is accomplished by rotating the HI/LO adjustment knob located near the center of the gas control valve. (Fig. 47)
Fig. 44 To open the front doors, turn handle counterclockwise.
Turn |
|
|
|
counterclockwise | �� | �� | Turn clockwise |
to decrease |
| to increase | |
|
|
RADIANCE |
Handle
Holder
ST656
flame height | flame height |
Fig. 47 Flame adjustment knob for Honeywell valve.
Flame Characteristics
It is important to periodically perform a visual check
Fig. 45 When not in use, store handle in the handle holder.
Your First Fire
Read these instructions carefully and familiarize yourself with the burner controls shown on Page 24. Locate the pilot assembly, Figure 46. Follow the lighting instructions on Page 24 exactly.
During the first fire, it is not unusual to smell some odor associated with new logs, paint and metal being heated. Odors should dissipate within the first eight to ten hours, however, you can open a window to provide
fresh air to alleviate the condition.
Pilot and Burner Inspection
Each time you light your heater check that the pilot flame and burner flame patterns are as shown in Figure
48.If flame patterns are incorrect, turn the heater off. Contact your dealer or a qualified gas technician for as- sistance. Do not operate the heater until the pilot flame is correct.
Follow regular maintenance procedures as described on Page 32.
20004188
of the pilot and the burner flames. Compare them to Figure 48. If any of the flames appear abnormal, call a service person.
PSE |
|
Pilot | SIT Pilot |
| CO105c |
Red Glow | LG157 |
Fig. 48 Correct pilot and burner flame patterns. | |
| 23 |
