Vermont Casting DVRT41 Operating Instructions, Glass Information, Louvre Removal, Glass Cleaning

DVRT41Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Specialty Home Products should be used on this fireplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with gasket) is available through your CFM Specialty Home Products dealer and should only be installed by a licensed qualified service person.

Louvre Removal

Window Frame

Assembly

Fireplace

Front

Clamps

Glass

Panel

Glass

Panel

Pull

Clamp Hook

Push

Clamp Handle

FP771

To remove louvre assembly top, pull louvre up and then lift out. The louvre assembly bottom is hinged at the bottom edge and swings down. (Fig. 45)

2.

1.Louvre

Glass Panel

FP444

Fig. 45 Remove louvre assembly top.

Fig. 46 Window frame assembly removal.

Glass Cleaning

It is necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia household cleaner and warm water (gas fireplace glass cleaner is recommended). After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot).

2.If the unit has been operating, allow time for the components to cool.

3.Remove louvre assembly top.

4.Open the louvre assembly bottom.

5.Release the two clamps along lower edge of the frame by pulling down on clamp handles. (Fig. 46)

6.Tilt window frame assembly out slightly at the bottom, lift the frame up and away from the fireplace.

7.To replace window frame assembly reverse proce- dure.

Clean the glass after the first two weeks of operation.

Do not clean glass when hot. Do not use abrasive cleaners. Do not strike or slam the glass.

Replacement Of

Ceramic Hearth Panels

1.Remove glass.

2.Remove two (2) screws securing grate to hearth pan. (Fig. 47)

3.Set left and right panels on hearth and bring towards front of unit.

4.Replace grate assembly.

10006740 23