Vermont Casting DVRT41 Direct Vent Gas Fireplace, 9b.Units with Honeywell valve, 10006740

Models: DVRT41

1 48
Download 48 pages 31.74 Kb
Page 46
Image 46
9b.Units with Honeywell valve:

DVRT41 Direct Vent Gas Fireplace

8.Remove the compression fitting which holds the aluminium tubing in the pilot assembly. This will reveal the pilot orifice which must be replaced with the one provided in the conversion kit.

9a. Units with SIT valve (Refer to illustrations in the installation instructions supplied with the kit):

a)Using a Torx T20 or slotted screwdriver, remove and save the three pressure regulator mounting screws (A), pressure regulator tower (B) and diaphragm (C).

b)Ensure the rubber gasket (D) is properly positioned and install the new Hi/ Lo pressure regulator to the valve using the new screws (E) supplied with the kit. Tighten screws securely. (Ref. torque: 25 in-lb).

c)Install the enclosed identification label (F) to the valve body where it can be easily seen.

9b.Units with Honeywell valve:

The Honeywell valve fitted to this unit is preset for LP gas. It is convertible to natural gas by the installation of a color coded “conversion screw.” To insert the conversion screw, refer to the instructions and diagrams in the Honeywell Installation Instructions supplied in the conversion kit packaged with the DVRT41RMH unit.

10.Reassemble the fireplace in the reverse order, except for the window frame assembly. Leave this off until the unit has been checked for leaks and the gas supply line has been bled.

11.After bleeding the gas line and checking for leaks with a soap solution, replace the window frame assembly. Fire up the unit, check for flame impingement on the logs, adjusting them if necessary. Check the manifold and supply pressures.

NOTE: If further assistance is required, refer to ‘Troubleshooting’ and ‘Parts List’ in this manual.

46

10006740

Page 46
Image 46
Vermont Casting manual DVRT41 Direct Vent Gas Fireplace, 9b.Units with Honeywell valve, 10006740