Vermont Casting DVRTSB manual Operating Instructions, Glass Information, Louvre Removal, 10003848

Models: DVRTSB

1 36
Download 36 pages 29.08 Kb
Page 21
Image 21
Operating Instructions

DVRTSB Bay Window Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this fireplace.

The use of any non-approved replacement glass will void all product warranties.

Care must be taken to avoid breakage of the glass.

Under no circumstances should this appliance be operated without the front glass in place, or with the glass in a damaged condition.

Replacement glass (complete with gasket) is available through your Majestic Fireplaces dealer and should only be installed by a licensed qualified service person.

Louvre Removal

The top side and top end louvres are removed by simply lifting the louvre assembly and pulling the assembly away from the fireplace. (Fig. 35)

The lower side louvres are hinged along the lower edge and are folded down for access to components in the base cavity of the fireplace.

The lower end louvre assemblies on the DVRTSB unit are removed in the same manner as the top louvre assemblies.

2.Glass Information

Louvre Removal Louvre

6.Tilt the lower edge of frame out slightly and lift glass/frame assembly up and away from the fireplace. (Fig. 36)

7.To reinstall the glass panel reverse this procedure.

 

Lower Clamps

 

 

 

Window

 

 

Frame

Window

 

Pull Clamp

Frame

Push

 

Hook

 

Clamp

 

 

Handle

 

FP1391

Fig. 36 Remove glass/frame assembly.

Side Glass Frame

1.

Remove the top and bottom louvre assemblies.

2.

Remove the lower window trim (held in place

 

with magnets).

3.

Remove both lower retaining screws. Access to

 

these screws is gained through the holes along the

1.

Glass Panel

Fig. 35 Louvre removal.

FP1390

 

lower edge of the frame behind the trim. (Fig. 37)

4.

Tilt lower edge of frame out slightly and lift glass/

 

frame assembly up and away from the fireplace.

5.

To reinstall the glass panel reverse the process.

Glass/Frame Removal

Front Glass Frame

1.Shut off the gas supply.

2.Allow the fireplace to cool if it has been in operation.

3.Remove the top louvre assembly.

4.Lower the bottom louvre assembly.

5.Release the two clamps along lower edge of the frame by pulling down on clamp handles. (Fig. 36)

Location of Lower

 

Retaining Screws

FP1392

Fig. 37 Remove end glass.

10003848

21

Page 21
Image 21
Vermont Casting DVRTSB manual Operating Instructions, Glass Information, Louvre Removal, Glass/Frame Removal, 10003848