Optional Top Vent Application
This appliance is shipped as a rear vent unit. If the installation layout requires the unit to be a top vent con- figuration the appliance can be converted by following the steps below.
When removing and refitting the plates and adapter be sure the associated gaskets are undamaged and refitted as required.
1. | Remove the 10 screws securing the outer collar |
| adapter to the fireplace body. (Fig. 9) |
2. | Set the collar aside, complete with the gasket. Do not |
| damage the gasket as the adapter and gasket must |
DVRTSB Bay Window Fireplace
Insulation
Flue
Cover
Flue
Pipe
Remove
Screws (4)
be refitted. |
3. Remove all of the insulation material (exposed in |
Step 2) from the top of the unit. (Fig. 10) This
Remove Screws (4)
Fig. 10 Remove flue cover and flue pipe.
FP1027
material can be discarded, however if the unit is con- verted back to rear vent for any reason a new piece of insulation material approved by CFM Corporation must be used for this purpose.
4.Remove the four (4) screws securing the flue cover plate to the top of the intake box and remove the cover and gasket. (Fig. 11)
5.Remove four (4) screws securing the flue pipe to back of the intake box and remove pipe and gasket. (Fig. 11)
6.Secure the plate and gasket removed in Step 4 over the flue opening in the back of the intake box. Ensure the gasket is in place and undamaged.
7.Install the flue pipe and gasket removed in Step 5 over the flue opening in the top of the intake box.
8.Refit the outer collar adapter and gasket to the unit with the round collar on the top. Secure the adapter with the 10 screws removed in Step 1.
When converting the appliance to top vent, ensure the insulation material referred to in Step 3 is com- pletely removed.
Rear View
Outer Col- lar Adapter
Flue
Pipe
Remove Screws
(5)
Remove |
|
Screws (5) | FP1030 |
|
Fig. 9 Remove screws from outer collar adapter.
Flue Cover Plate
Flue
Pipe
FP1378
Fig. 11 Remove flue pipe and flue cover plate.
10003848 | 9 |
