DVRTSB Bay Window Fireplace
Glass Cleaning
It is necessary to periodically clean glass. During start- up condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to glass surface.
Also initial paint curing may deposit a slight film on the glass. It is therefore recommended glass be cleaned two or three times with a
After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.
Clean the glass after the first two weeks of operation.
Ceramic Refractory Installation
The rear wall refractory panels are installed in the unit prior to shipment.
1.Unpack the ceramic refractory panels from their carton.
Handle the refractory material carefully, the panels are fragile.
2.Place the front floor refractory panels on the base of the fireplace. (Fig. 38)
3.Place both side panels in place along the side of the base. (Fig. 38)
| FP1393 |
Fig. 38 | DVRTSB ceramic panels. |
22
Installation of Logs
The logs can be identified by the number cast into their underside.
The logs must be correctly placed in the order described for the correct operation of the fireplace.
Refer to Figures 30 & 40 for log location and alignment.
1.Unpack the logs from the shipping carton. Handle the logs carefully as they are fragile.
Handle and dispose of the plastic bags in a safe manner. They are not toys and should be kept away from infants.
2.Remove front glass/frame assembly.
3.Place the left rear (B105) and right rear (B106) logs in place on the grate. The square hole in the underside of the logs locates over the corner legs of the grate. The inner ends of the log point to the center of the burner.
4.Place the left front (B107) and right front (B108) logs in place. Again the square holes fit over the corner legs of the grate. The inner ends of these logs have a recess in the underside which locates over knobs on the top of the B105 and B106 logs to lock the inner end in place.
5.Place the center front (B109) log in place. The notch on the outer end of this log locates around the third outer prong on the grate and the inner ends with a round recess rest on lug on top of the left front log (B107).
6.Place the center rear (B110) log in place. The square hole in the underside of this log, locates over the rear center bar of the grate. The inner end of the log having a rectangular recess rests on the rectangular knob on the end of the left front log, (B107).
B105 | B110 | |
| ||
|
| B106 |
| B107 | B108 |
|
| |
| B109 |
|
|
| LG298 |
Fig. 39 | DVRTSB logs. |
|
|
| 10003848 |
