Chateau™ Direct Vent Gas Fireplace

Control System

The gas control system is located on the right hand side of the firebox behind an access panel and the decora- tive brick panel. The fireplace is operated using only the hand held remote control unit. The system wiring diagram is shown in Figure 11. NOTE: If you choose to install the battery back-up, Model DVTBBK, refer to Item #16 in the next section.

Control System Installation

Gas Supply Fitting

Pressure

Test

Ports

Learn Button

1.Locate the fireplace in the desired location.

2.Remove the glass. Refer to Glass Frame Assembly Removal section.

3.If installed, remove the lava rock, volcanic rock, andirons, embers and logs, making note of each log’s location.

4.If installed, remove the refractory brick panel on gas supply side.

5.Using a back-up wrench, disconnect the gas supply fitting. (Fig. 7)

Cover

Plate

Gas Sup- ply Fitting

FP1801

Fig. 7 Disconnect gas supply fitting and remove 13 screws securing the cover plate.

6.Remove pilot assembly from burner assembly by removing two (2) screws.

7.Carefully slide the burner assembly out of the way, taking care not to bend or break the pilot tubes or wiring.

8.Remove 13 screws around the perimeter holding large access panel on the side of the firebox.

9.Carefully pull back the panel just enough to gain access to control box.

10.Connect the gas supply to the valve. (Fig. 8) Be sure to use a back-up wrench when tightening sup- ply fitting.

FP1802

Fig. 8 Connect gas supply to valve.

11.Connect a 120V AC electrical supply to the junc- tion box duplex outlet. Use a Romex-type strain relief connector when running wires out through the box knockout. Replace the duplex outlet and cover plate.

12.Plug the AC adaptor plug into the duplex outlet.

13.This control system must now be programmed to the hand held remote control transmitter. To pro- gram the remote control, make sure the 120V AC is connected and powered to the fireplace.

14.Remove the battery door on the back of the hand held remote control and install two (2) supplied “AAA” batteries. Be sure to note correct polarity. Replace battery door.

15.Locate the learn button on the main module. (Fig.

9) Press and release the learn button using a pencil point. There will be a beep sound from the module. Then press any key on the remote control transmit- ter. Once the module’s internal receiver accepts the transmitter code, there will be a series of confirming beeps.

16.If you chose to install the optional back-up battery pack (No. DVTBBK), you must install a wall box from 3’ (914 mm) to within 15 feet (4.6 m) of the fireplace. Assemble the connectors on one end of the supplied extension wire harness to the mating connectors on wire harness within the control box. Make sure to connect black coded wire to black and red coded wire to red.

17.The other end of the extension wire harness should be connected to the wiring of the back-up battery holder located within a wall box.

18.Insert the supplied four (4) “AA” batteries into the battery older. Be sure to note correct polarity for each battery.

8

20011957

Page 8
Image 8
Vermont Casting DVT38S2IN installation instructions Control System Installation