Chateau™ Direct Vent Gas Fireplace

6. Position the log burner overlay.

Figure 45

(Fig. 45) The overlay is very fragile

and must be handled with extra

care. Hold the overlay with the flat

surface facing down. The notched

corners of the overlay should be on

the side of the pilot. Set the overlay

on top of the burner housing and

align it right to left over the burner

housing. Make sure the overlay fits

between the two (2) fettles.

7. Position the log grate/burner

tube. (Fig. 46) Hold the log with

the pointed end down and the flat

surface away from you. Slide the

wider end of the log at an angle in

the third opening “middle” of the

fettle. Hook the log on the fettle

and set down over the burner tube

assembly. Repeat the same proce-

dure on the opposite side.

8. Position the log left grate. (Fig. 47)

Hold the log with your left hand

with the pointed end toward the

right and the flat surface facing

down. Set the log on the inside of

the fettle toward the left over the

overlay and hook the branch and

the pointed end of the log through

the first and second opening on the

fettle by using the second and third

tine. When the log is in place, it

will be sitting at an angle in the air

above the overlay. Repeat this step

for opposite side.

9. Position the log middle. (Fig. 49)

Familiarize yourself with notches

located on the flat surface of the

LG501

LG502

Figure 47

Log Overlay (F56)

Figure 46

Log Grate/Burn- er Tube (F51)

Log Middle (F52)

Log Left

log on each end. These notches

are utilized in positioning the log.

Hold the log with the flat surface

facing down and the burned out

end closer to you.

NOTE: Position this log through the side with the control valve box on the left side. Set the log using the notches mentioned earlier located on the flat surface of the log and using the center tine on each fettle. When the log is in place, the notches located on the bottom of the log will set directly above the center tine on each fettle.

Log Left Grate Grate

(F53)(F53)

LG503

30

20011957

Page 30
Image 30
Vermont Casting DVT38S2IN installation instructions Overlay is very fragile