Vermont Casting DVT38S2IN Chateau Direct Vent Gas Fireplace, Special Feature for Cold Climates

	Chateau™ Direct Vent Gas Fireplace
White or Green	To Pilot Ignitor
Green or White
White or Orange
Orange or White	To Pilot
	Flame Sensor

DC Motor		Pilot		Main
		AF-4000		Module
	Main			Learn
				Button
Black			Power	Orange
			Module	Red
Red				Brown
				Black

Pulse/Continuous

Button

AC Adaptor

FP1795

Brown

Brown

Red

Black

I

S

Remote Battery

Back-Up Pack

Remote/Off

Switch

Continuous

Pilot ON/OFF

Switch

Black Gnd Red Black

(SWI) (Optional

(SWI) ON/OFF Switch)

Extension Harness

Fig. 9 DVT38S2 wiring diagram.

19.Mount electrical wall box containing back-up bat- teries at a convenient location from 3’ (914 mm) to 15’ (4.6 m) of the fireplace. Cover wall box using a blank wall plate.

20.The fireplace remote system is ready for use.

21.Reassemble access panel, burner assembly, gas supply connector, brick panels, logs, embers, andirons and lava rock in reverse order of removal. (Refer to Log, Lava Rock and Ember Placement section.

22.Turn on gas supply and check that all connections are tight and leak free.

NOTE: If you need to test the inlet pressure and/or manifold pressure, there are two (2) test ports available along the front edge between the firebox side and outer casing. The upper test port is inlet pressure. The lower test port is manifold pressure. (Refer to Figure 8)

CAUTION: Turn off the gas supply before removing test port plug.

23.Using a 7/16” nut driver, remove the threaded plug from the test port.

24.Thread the supplied extension adaptor into the open test port.

25.Attach a 1/4” diameter pressure gauge flexible hose fully onto the barb of the adaptor.

26.Turn on gas supply and operate valve with remote control as needed to indicate gas pressure.

CAUTION: Turn off the fireplace and gas supply before removing test port adaptor and replacing plug.

27.After test, remove extension adaptor and replace plug securely.

28.Turn on gas supply and check that plugs are tight and leak free.

Special Feature for Cold Climates

This gas control system has the option of a continu- ous pilot feature. This allows the user to change from a spark to pilot system to a standing pilot system for direct vent appliances during cold climate conditions to keep the firebox warm.

When the continuous pilot mode is activated and the fireplace is turned ON, the pilot will spark and light. When the fireplace is turned OFF, the pilot will stay ON when the main burner shuts OFF.

The continuous pilot mode can be activated or de-acti- vated by the hand held remote control transmitter.

20011957 9