Vermont Castings Jefferson Vent Free Gas Heater
2.Disconnect the snapstat module from the leads inside the snapstat bracket. (Fig. 8)
3.Bend open the snapstat bracket. use your fingers or needle nose pliers to remove the black plastic grommet from the bracket. Discard the grommet and bracket.
Pinch Grommet to Remove
Snapstat
Bracket
Snapstat
Module
ST468
Fig. 8 Remove snaptstat and grommet from bracket.
4.Secure the snapstat to the upper middle of the inner shroud. (Fig. 9) NOTE: The snapstat location may be reached through the front of the stove between the top and the firebox or you may loosen the four screws holding the rear shroud in place. Be sure to secure shroud back into place before operation.
5.Connect the two wires to the two snapstat extension leads attached to the inner shroud. You may coil excess wire up inside the rear shroud.
Snapstat
ST346a
Fig. 9 Attach snapstat to inner shroud.
6.Route the rheostat control switch and wire forward under the stove. (Fig. 10) Use the wire tie to secure the fan and rheostat wire harnesses together to the tubing under the heater.
| Rheostat |
Retaining Nut |
|
Control Knob | ST347a |
Fig. 10 Attach rheostat to control panel. Valve may look different.
MOTOR |
|
| |
BLK |
| BLK | BLK |
|
|
| |
|
|
| SNAPSTAT |
|
| BLK | WHT |
WHT | GRN | ON/OFF |
|
RHEOSTAT |
| ||
|
|
| ST236 |
Fig. 11 | Fan wiring diagram. |
|
Install ON/OFF Switch
(R Models only)
The switch assembly parts are found in the parts bag.
1.Attach switch assembly to left rear side of stove shroud using two screws and existing holes in shroud. (Fig. 12)
2.Run wires down back of stove, under bottom of rear shroud to valve.
3.Attach wires to valve terminals. (Fig. 13)
Switch | Existing Holes | |
Assembly | ||
| ||
Screws | ST315 | |
| ||
Fig. 12 Attach switch assembly to rear shroud. |
TH |
TP |
TPTH |
ST228
Fig. 13 Attach switch wires to valve.
10 | 20003447 |