Verona VECTGMS304SS Low Flame Adjustment, Lighting gas burners with a match is danger, flame

		Installation Manual
		ENGLISH
Low Flame Adjustment		ONE RING FLAME
	DANGER
Lighting gas burners with a match is danger-
ous. You should match light the cooktop burn-
ers only In an emergency.
Light a match and hold the flame near the burner
you want to light. Wooden matches work best.
Push in and turn the control knob slowly.
Be sure you are turning the correct knob for the
burner you are lighting.
NOTE:
If the burner does not light within five seconds, turn
the knob off and wait one minute before trying again.
	WARNING	TWO RINGS FLAME
If you attempt to measure the inner cone of the
flame, please use caution.
Burns could result.
This appliance is shipped from the factory with low
and medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
Adjustment for Burners with one or two rings
flame:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Insert a slender, thin-blade screwdriver into the
recess at centre of valve stem and engage blade
with slot in adjusting screw.
4. Turn center stem adjusting screw to set flame
size:
•	clockwise to reduce

• counterclockwise to increase Figure 21. Low flame adjustment

5.Replace control knob when adjustment is com- pleted.

19