OPERATIONS
POWER Indicator | STANDBY/ON Button | STANDBY/ |
ON Button |
FOCUS button
ZOOM button
Power Switch
| FOCUS button |
Lens cap | ZOOM button |
|
Power ON
1Check if the power cord is connected correctly.
2Set the power switch to [I]. When the standby mode is selected, the POWER indicator is orange.
3Press the STANDBY/ON button on the control panel or the remote control device. The
4The POWER indicator stops blinking and turns green when the power is on. Remove the lens cap.
5Adjust picture size with the ZOOM button.
6Adjust focus with the FOCUS button.
Power OFF
1Press the STANDBY/ON button on the control panel or the remote control device. Then the message "Power off?" will appear on the screen, and the message will disappear by any operation or if no operation is carried out for 5 seconds. During this message indication, press the STANDBY/ON button again. The projector lamp is turned off and the lamp will be cooled down. The POWER indicator blinks orange when the lamp cools down. Pressing the STANDBY/ON button has no effect while the POWER indicator is blinking.
2The system goes into the Standby mode after cooling and the POWER indicator stops blinking and changes to orange. Check if the indicator is orange and set the power switch to [0].
3The POWER indicator goes out when the power is switched off. Attach the lens cap.
WARNING: Before using this equipment, read this manual thoroughly. Always ensure that the equipment is used safely.
NOTE: • Except in emergencies, follow the
•To prevent any trouble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a
•If the projector continues projecting the same image, the image may remain as an
ViewSonic PJ1065 | 9 |
