ViewSonic PJ1065 No Signal Menu, Volume Adjustment Reduce VOLUME, Operation Start/Stop Press the

No Signal Menu

The same adjustments and settings are available as with the Image and Options menus when the MENU button is pressed during display of the “NO INPUT IS DETECTED ON***”or “SYNC IS OUT OF RANGE ON***”message while no signal is received.

Table 8: No Signal Menu

Item		Description
	Volume Adjustment: Reduce VOLUME		Increase VOLUME
	• When this function is used, audio input is automatically switched to video. The
VOLUME	audio input can be switched by moving the DISK PAD left and right during the
	display of the volume adjustment bar. The volume adjustment bar is displayed by
	pressing VOLUME	or VOLUME button.
	Select Blank Screen: Select the screen with the /				button.The selected one
	(MyScreen, ORIGINAL or one colors) is displayed when the BLANK mode is ON.
	MyScreen is a mode that the customer-customized screen is displayed. This is
BLANK	the blue screen at the factory setting. Refer to the description of MyScreen below.
	ORIGINAL is a mode that the factory fixed screen is displayed.
	• When MyScreen or ORIGINAL is selected, the screen is going blank after
	several minutes.
	Select Start Up Screen:Select the screen in case of no signal input with the /
	button. The selected one (MyScreen, ORIGINAL or TURN OFF) is displayed
	when no signal is input
	MyScreen is a mode that the customer-customized screen is displayed. This is
START UP	the blue screen at the factory setting. Refer to the description of MyScreen below.
	ORIGINAL is a mode that the factory fixed screen is displayed.
	TURN OFF displays the blue screen.
	• When MyScreen or ORIGINAL is selected, the screen is going blank after
	several minutes.
MIRROR	Operation Start/Stop: Press the		button.
	Select Mirror Status: Select the mirror status with the				and	buttons.
MENU COLOR	Select Menu Background Color: Select the color with the					and	buttons.
LANGUAGE	Operation Start/Stop: Press the		button.
	Select Menu Display Language: Select the language with the					and	buttons.
	Operation start/stop: Press the		button.
	Set AUTO OFF: Set 1-99 minutes with the		and		buttons. The system
	automatically enters the standby mode when a signal is not received for the set
AUTO OFF	time.
	Clear AUTO OFF: Select the STOP (0 min.) with the				button. When STOP is
	selected the system does not enter the standby mode even if no signal is
	received.
	Operation Start/Stop: Press the		button.
	SYNC ON G Valid: Select the TURN ON with the			button.
SYNC ON G	SYNC ON G Invalid: Select the TURN OFF with the				button.
	• May not be displayed correctly with some input signals when the SYNC ON G is
	valid. In such cases, remove the signal connector so that no signal is received,
	set the SYNC ON G to invalid, and reconnect the signal.
	Set / Clear WHISPER Mode: Press the		button. When WHISPER is
WHISPER	selected, the WHISPER mode is active. In the WHISPER mode, acoustic noise
	level from the unit is reduced, and brightness level on screen is a little lower.

16ViewSonic PJ1065