ViewSonic manual OPTION Menu, Description, ViewSonic PJ510

OPTION Menu

With the OPTION menu, the items shown in the Table below can be performed. Perform each operation in accordance with the instructions in the table below.

Item		Description
VOLUME	Adjust the Volume: High (S) Q (T) Low
SCREEN TYPE	Select the Screen Type:
	4:3(S)Q(T)16:9-TOP(S)Q(T)16:9-CENTER(S)Q(T)16-9:BOTTOM
	•	Please select the screen type used and the picture position in case of 16:9. This selection is used
		as basic information for a suitable display. This function should be performed before other picture
		adjustment.
LAMP TIME	To begin the operation of this item, please press the (X) button of the projector or the RESET button
	of the remote control for 3 seconds.
	Reset the Lamp Timer:
	Selecting the RESET performs this function
	RESET (S)  CANCEL
	•	The numerical value of four digits shown on this menu is the projector use time since the last
		RESET operation of this item. The value is reset to 0 at the same time the RESET is selected.
	•	The value of this function is used to display the message of “CHANGE THE LAMP”. So this
		function must be performed only immediately after replacing the lamp.
		Do not perform this function unless you have replaced the lamp. Perform this function every time
		the lamp is replaced. Incorrect performing of this function causes incorrect operation of the
		message function.
	•	After the lamp running reaches 2000 hours, a warning message is displayed: “To maximize
		performance, lamp replacement is recommended.”, but won’t shut the unit off. The message
		display for 30 seconds when the PJ is turned on. If we push any button while displaying the
		message, the message disappears.
	•	Please see to the section “Lamp” about replacing the lamp.
FILTER TIME	To begin the operation of this item, please press the (X) button of the projector or the RESET button
	of the remote control for 3 seconds.
	Reset the Filter Timer:
	Selecting the RESET performs this function
	RESET (S)  CANCEL
	•	The numerical value of four digits shown on this menu is the projector use time since the last
		RESET operation of this item. The value is reset to 0 at the same time the RESET is selected.
	•	The value of this function is used to display the message of “CLEAN THE AIR FILTER”. So this
		function must be performed only immediately after cleaning or replacing the air filter.
		Do not perform this function unless you have cleaned or replaced the air filter. Perform this
		function every time the air filter is cleaned or replaced. Incorrect performing of this function causes
		incorrect operation of the message function.
	•	Please see to the section “Air Filter” about cleaning and replacing the air filter.
RESET	Reset the OPTION Menu Items:
	Selecting the EXECUTE performs this function.
	EXECUTE (S)  CANCEL
	•	The SCREEN TYPE item is returned to the initial setting. Note that the items VOLUME, LAMP
		TIMER and FILTER TIMER are not reset.

29 ViewSonic PJ510