Visioneer 9000 manual What YOU Need

4VISIONEER 9000 USB SCANNER INSTALLATION GUIDE

WHAT YOU NEED

To use the 9000 OneTouch scanner and software, you need the following:

■IBM PC (or 100-percent compatible) Pentium or equivalent

■Microsoft Windows 98, Windows 2000, Windows Me, or Windows XP

■One available Universal Serial Bus (USB) port; the scanner can connect to either a USB1.1 or to a faster USB 2.0 port (see the note below)

■Available internal memory (RAM):

■Windows 98—32 megabytes (MB) or more

■Windows 2000, Me, or XP—64 MB or more; 128 MB recommended for Windows XP

■70 MB of free hard disk space

■A VGA or SVGA monitor. Recommended settings for your monitor are as many colors as possible—High Color (16-bit), True Color

(24-bit or 32-bit). Set the resolution to at least 800 by 600 pixels. To set your monitor’s colors and resolution, open the Windows Control Panel, double-click Display, and then click the Settings tab.

■A CD-ROM drive

Note: The new USB 2.0 ports operate at higher speeds than USB 1.1 ports. If your computer is not equipped with USB 2.0 ports, you can add them with the Visioneer Hi-Speed USB 2.0 PCI Card. Please visit the Visioneer web site at www.visioneer.com for ordering information, or contact the dealer where you purchased your Visioneer 9000 OneTouch USB scanner. However, you do not have to add USB 2.0 ports to the computer. Your scanner automatically works with both USB 1.1 and USB 2.0 ports.