VISTA-10SE Installation and Setup Guide
14-10
Important Note: If “15” is entered in field ✱95 to bypass an answering machine,
and a 4285/4286 VIP Module is included in the installation, you shou ld note the
following:
When calling in from an off-premises phone (to receive a status report or execute a
command), the user should make the initial call, allow 1 to 3 rings only, and hang
up. Then call in again. The VIP Module will now seize the line, and 2 long tones
will be heard, followed by the usual voice prompt for the 2-digit pho ne access co de.
If this procedure is not followed, VIP Module operation w ill not be possible.
✱96 INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. NO.
FOR DOWNLOADING (No data entry required; press ✱96)
✱97 SET ALL PROGRAM FIELDS TO DEFAULT VALUES
(No data entry required; pressing ✱97 automatically loads all
ADEMCO defaults). Do not use if previously programmed with other
values.
TO EXIT
PROGRAMMING
MODE
(✱98 or ✱99)
✱98 EXITS PROGRAMMING MODE and prevents re-entry by :
INSTALLER Code + 8 + 0.
To enter the Programming mode if ✱98 was used to exit, you must
first power the system down. Then power-up again, and depress [✱]
and [#] both at once, within 50 seconds of powering up.
✱99 EXITS PROGRAMMING MODE and allows re-entry by:
INSTALLER Code + 8 + 0 or by method described in paragraph
above (power down, power-up and depress [✱] and [#] both at once,
within 50 seconds of powering up).