Section 15 - Zone Programming
15–9
If you want to replace the serial number continue to step 4; otherwise, skip to step 7.
A display for the new transmitter number appears.
10 INPUT S/N: L
AXXX-XXXX 1
4. Key the transmitter. The new transmitter serial number re places the X’s in the display.
5. The new summary display appears with a small “s” next to the loop n umber to indicate
that the new transmitter serial number has been learned.
NOTE: Be sure to remove one of the serial number labels from the new transmitter an d affix
it over the old serial number label in the ENROLLED TRANSMITTERS worksheet in the
Programming Form.
6. Press the [✱] key repeatedly until “Enter Zone Number” prompt is displayed.
7. To exit, enter 00.
8. Press ✱99 to exit the Programming mode.
To Enter and Duplicate Wireless Keys
If you pressed the [D] key previously (from the beginning of the ✱56 mode) to enter and
duplicate 5804 and/or 5804BD wireless keys, the following screens appear:
TEMPLATE ?
1–61
1. Enter Template number 1–6 (next page).
1–3 = 5804 templates; 4–6 = 5804BD templates. See the defaults
provided for each template in the chart that follows these
procedures.
2. Select from templates. Press [✱] to display temp late (1 shown
selected). NOTE: If necessary, press [#] to back up and re-enter
template number.
3. Press [#] if you want to return to zone attributes sc reen.
L 01 02 03 04
T 23 22 21 23
4. When you press [✱], the selected template is displayed.
Top line of display represents loop numbers, bottom line
represents zone type assigned for each zone.
5. Press [✱] to accept template.
ENTER START ZONE
00 = QUIT 22
Example of zone ↑
suggested by the
system. This indicates
that zones 22, 23, 24,
and 25 are available.
6. The system searches for the highest zone number available,
subtracts the number of consecutive zones required for the
device (four zones in the case of the 5804 and 5804BD), and
displays the lowest zone number of the group.
If you want to start at a different zone, enter the zone desired
and press [✱].
If that zone number is displayed, the system has the requ ired
number of consecutive zones available, beginning with the zone
you entered. If not, the system again displays a sugge sted zone
that can be used.
If the required number of consecutive zones is not available at
all, the system displays “00.”
7. Press [✱] to accept.
INPUT S/N L
AXXX-XXXX –
8. Enter the serial number of the wireless key or depress any
button to transmit from the wireless key.
9. Press [✱] to accept the serial number.
The system checks for a duplicate number.
If a duplicate exists, a long error beep will sound and the serial
number reverts back to all "X"s allowing you to re-enter the
serial number.