C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
DOOR
Removal
1.Close door.
2.Remove left SIDE PANEL.
3.Remove nuts from upper hinge located inside front panel.
4.Open door slightly, and while holding door, pull upper hinge away from front panel.
5.Pull upper hinge out of upper door hinge bushing.
6.Lift door assembly up and off lower door hinge.
7.Reinstall parts removed in reverse order of removal.
8.Check door for fit and proper sealing of gasket.
Gasket
1.Open door.
2.Remove the shoulder screws and pan pusher bracket from gasket plate.
3.Remove gasket plate.
4.Remove gasket from inner door panel.
5.Remove RTV from bottom part of inner door panel. Apply new RTV 109 to bottom of door where shown when assembling gasket to door.
6.Place a small amount of RTV109 into the inner door panel gasket screw holes before assembly.
7.Position the new gasket on gasket plate and reverse procedure to install.
Handle Removal
1.Open door.
2.Remove screws from top and bottom of door assembly.
3.Pull outer door housing away from inner door panel starting at the hinge side of door to separate the door halves.
NOTE: The smaller radius of the step spacers fit into the slots of the outer door housing and is used to provide clearance for handle operation.
4.Remove lock nuts and stepped spacers from threaded studs of door handle.
F25386 (June 2010) |
| Page 10 of 24 |
|