C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS

Assembly

1.Apply Lubriplate 630AA to sides of sliding bracket.

2.Insert spring pin into bottom of sliding bracket. A. Place spring over spring pin.

3.Assemble sliding bracket into stationary bracket.

4.While holding head of spring pin against bottom of sliding bracket, insert spring pin into keeper hole in bottom of stationary bracket.

3.Check opening and closing operation of door.

4.Check steamer for proper operation and leaks around door seal.

Hinge Bearings

1.Close door.

2.Remove left SIDE PANEL.

3.Remove nuts from upper hinge located inside front panel.

A. Secure spring pin in place with retaining pin.

NOTE: Install pins such that heads of pins will be facing inward toward hinge side of inner door panel when latch assembly is installed.

5.Install pins to assemble stationary and sliding brackets together.

A. Secure pins into position with E-clip.

Installation

1.Install latch assembly onto inner door panel with spring pin toward bottom of door panel.

A.Apply Loctite 271 to threads of screws before assembly and secure latch assembly to inner door panel.

2.Install outer door housing assembly as outlined in DOOR HANDLE INSTALLATION.

4.Open door slightly, and while holding door, pull upper hinge away from front panel.

5.Pull upper hinge out of upper door hinge bearing.

6.Lift door assembly up and off lower door hinge.

7.Pry hinge bearing out from door assembly.

8.Remove outer door housing.

Do not drive bearing into place. The inner door panel could be damaged. Press bearing into position.

NOTE: When replacing door hinge bearings, replace both hinge bearings.

9.Position replacement hinge bearing over hinge opening in door assembly.

A.Press hinge bearing fully into door assembly using a C-clamp or equivalent.

10.Reassemble parts removed in reverse order.

11.Check door for fit and proper door gasket sealing.

F25386 (June 2010)

 

Page 12 of 24