C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
C.Install thermostat hand tight. Do not over tighten.
1.Remove right SIDE PANEL.
2.Remove screw and heat shield.
TEMPERATURE PROBE
1.Remove right SIDE PANEL and REAR PANEL.
2.Disconnect probe leads from the temperature control.
3.Remove temperature probe from steam vent pipe.
4.Reverse procedure to install replacement probe and check steamer for proper operation.
5.Adjust temperature control as outlined under TEMPERATURE CONTROL CALIBRATION in
SERVICE PROCEDURES AND ADJUSTMENTS.
3. Remove bolts.
NOTE: Support heating element assembly while removing last bolt.
4.Disconnect heating element leads from 1CON and 2CON, noting their locations.
HEATING ELEMENT ASSEMBLY
Removal
The heating element assembly contains elements molded into a cast aluminum block. The block is mounted on the underside of cooking compartment. Heating element assembly sits on springs which compress to hold assembly tight to bottom surface of steam chamber but allow for thermal expansion and contraction.
F25386 (June 2010) |
| Page 8 of 24 |
|